This version (31 Oct 2023 15:15) was approved by iulia Moldovan.The Previously approved version (13 Dec 2021 10:59) is available.
Table of Contents
AD9081/AD9082 Quick Start Guides
The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the AD9081-FMCA-EBZ and AD9082-FMCA-EBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.
Supported Carriers
The AD9081-FMCA-EBZ and AD9082-FMCA-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:
Supported Environments
Quick Start Guides
ZC706 + AD9081-FMCA-EBZ
ZCU102 + AD9081-FMCA-EBZ
VCU118 + AD9081-FMCA-EBZ
VCK190/VMK180 + AD9081-FMCA-EBZ/AD9082-FMCA-EBZ
A10SoC + AD9081-FMCA-EBZ
Hardware Setup
In most carriers, the AD9081-FMCA-EBZ board connects to the HPC0 connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), DisplayPort or HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.
Board setup
The following rework is required:
- In order to avoid using an external clock source and fully rely on the HMC7044 clock chip, rotate the C6D/C4D caps in C5D/C3D position (Please note: In the latest version of the board, this is now the default configuration, so this configuration step might not be needed anymore)
- If LEDS V1P0_LED and VINT_LED are not on please depopulate R22M and populate R2M
HDL Reference Design
Software support
Useful links
-
-
-
-
- MATLAB support is provided through the High Speed Converter Toolbox
-
- PYTHON support is provided through the Device Specific Python Interfaces For IIO Drivers
- Product Datasheet
Support
Analog Devices will provide limited online support for anyone using the reference design with Analog Devices components via the EngineerZone.
resources/eval/user-guides/ad9081_fmca_ebz/quickstart.txt · Last modified: 31 Oct 2023 15:15 by iulia Moldovan