Wiki

Analog Devices Wiki

English
English
简体中文
简体中文
日本語
日本語
Руccкий
Руccкий
This version is outdated by a newer approved version.DiffThis version (09 Jul 2020 12:53) is a draft.
Approvals: 0/1The Previously approved version (03 Jul 2020 09:37) is available.Diff

This is an old revision of the document!

Table of Contents

The following instructions are correct for developers using Ubuntu 18.04 LTS.

Installing Required Packages

In order to build and deploy Linux to your ADSP-SC5xx development board you will need to install several additional packages on to your host PC. This can be performed using the following command and respond yes(y) to any prompts: 

$ sudo apt-get update
$ sudo apt-get install gawk wget git-core diffstat unzip texinfo gcc-multilib build-essential chrpath socat libsdl1.2-dev xterm u-boot-tools openssl curl tftpd-hpa python

Setting Up TFTP

We use the TFTP server on the host to transfer images to the EZ-KIT. This needs to be configured for use: 

$ sudo vi /etc/default/tftpd-hpa

#add following commands 
TFTP_USERNAME="tftp"
TFTP_DIRECTORY="/tftpboot"
TFTP_ADDRESS="0.0.0.0:69"
TFTP_OPTIONS="--secure"

$ sudo mkdir /tftpboot
$ sudo chmod 777 /tftpboot
$ sudo service tftpd-hpa restart

Setting Up NFS Server

We use the NFS server on the host to transfer images to the EZ-KIT. This needs to be configured for use: 

$ sudo apt-get install nfs-kernel-server
$ sudo vi /etc/exports

#Add following commands
/romfs *(rw,sync,no_root_squash,no_subtree_check)

$ sudo mkdir /romfs/
$ sudo chmod 777 /romfs/
$ sudo service nfs-kernel-server start

Configuring Minicom

In order to communicate with the U-Boot bootloader, a UART connection must be made between the host PC and the development board. It is recommended that you use minicom to do this. Minicom must be configured to connect to U-Boot correctly.

On the host PC open a terminal and execute the following commands: 

$ sudo apt-get install minicom
$ sudo minicom -s

            +-----[configuration]------+
            | Filenames and paths      |
            | File transfer protocols  |
            | Serial port setup        |
            | Modem and dialing        |
            | Screen and keyboard      |
            | Save setup as dfl        |
            | Save setup as..          |
            | Exit                     |
            | Exit from Minicom        |
            +--------------------------+


# Select Serial port setup
     Set Serial Device to /dev/ttyUSB0
     Set Bps/Par/Bits to 57600 8N1
     Set Hardware Flow Control to No
     
     Close the Serial port setup option by press Esc
 Select Save setup as dfl
 Select Exit

HOME PAGE: Linux for ADSP-SC5xx Processors NEXT: Setting Up Sources

resources/tools-software/linuxdsp/docs/quickstartguide/setting_up_your_host_pc.1594292026.txt.gz · Last modified: 09 Jul 2020 12:53 by cathy fang

Page Tools