Wiki

Analog Devices Wiki

English
English
简体中文
简体中文
日本語
日本語
Руccкий
Руccкий

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
resources:fpga:altera:ced1z:common_troubleshooting [30 Nov 2011 15:41] – Moved title to the main page so the table of content to be generated correctly Adrian Costinaresources:fpga:altera:ced1z:common_troubleshooting [25 May 2012 12:43] (current) – Added the "More information" section Andrei Cozma
Line 3: Line 3:
   * Check that the evaluation board is powered.   * Check that the evaluation board is powered.
   * Make sure the USB cable is not connected to the CED1Z. In case it is, disconnect it and reset the board.   * Make sure the USB cable is not connected to the CED1Z. In case it is, disconnect it and reset the board.
-  * Check that the USB Blaster cable is properly connected to the device and to the computer and that the **//USB Blaster Device Driver//** driver is installed correctly. If the deriver is not correctly installed perform the steps described in the **//Getting Started -> Install te USB-Blaster Device Driver//** section.+  * Check that the USB Blaster cable is properly connected to the device and to the computer and that the **//USB Blaster Device Driver//** driver is installed correctly. If the driver is not correctly installed perform the steps described in the **//Getting Started -> Install te USB-Blaster Device Driver//** section.
   * In uC-Probe right-click on the **//System Browser//** window select **//Remove Symbols//**. A dialog box will open to select the symbols to remove. Press OK to remove the symbols.   * In uC-Probe right-click on the **//System Browser//** window select **//Remove Symbols//**. A dialog box will open to select the symbols to remove. Press OK to remove the symbols.
  
Line 17: Line 17:
 {{ :resources:fpga:altera:bemicro:image081.png?300 }} {{ :resources:fpga:altera:bemicro:image081.png?300 }}
  
-  * Run the //**ADIEvalBoard/uCProbe/data_capture.bat**// script. A DOS command prompt window will open. This window must be closed only when the uCProbe demonstration project will be +====== More information ====== 
 +  * [[ez>community/fpga|ask questions about the FPGA reference design]] 
 +  * Example questions: {{rss>http://ez.analog.com/community/feeds/allcontent/atom?community=2061 5 author 1d}}
resources/fpga/altera/ced1z/common_troubleshooting.txt · Last modified: 25 May 2012 12:43 by Andrei Cozma

Page Tools