This version (12 Feb 2019 00:22) was approved by Sundar Palani.

EVAL-ADPAQ3029 - ADC demo

Download firmware and Tile application from below

ADC Firmware

Tile GUI application
Follow the same steps as given here
A potentiometer has been used in this project to modify the analog voltage values.
The potentiometer has to be interfaced with the ADPAQ module. The connections between the potentiometer and the ADPAQ module are described in the table below.

Potentiometer Pins GPIO port used ADPAQ Header Pins

A VCC P1-3.3V

B ADC0_Vin0 P1-ADC0_Vin0

C GND P1-GND_POWER
Build and run the project
If the knob of the potentiometer is rotated, the ADC value should vary between 0-4095 for the corresponding analog voltage variations from 0 to 3.3V.

Wiki