Wiki

Analog Devices Wiki

English
English
简体中文
简体中文
日本語
日本語
Руccкий
Руccкий

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
resources:eval:user-guides:ev-cog-ad4050lz:help_support [12 Aug 2017 09:38] – [What to do When Things Go Wrong] Pranit Jadhavresources:eval:user-guides:ev-cog-ad4050lz:help_support [03 Jan 2021 22:04] (current) – fix links Robin Getz
Line 1: Line 1:
 ====== Help and Support ====== ====== Help and Support ======
 +
 +<note >There are no seperate toolchain,On-Board Peripheral Drivers & Software for EV-COG-AD4050WZ, the toolchain,On-Board Peripheral Drivers & Software for EV-COG-AD4050LZ works with EV-COG-AD4050WZ.The user needs to change only the pin muxing based on the application.For help regarding pinmapping refer to the Hardware Details section.
 +</note>
  
 Do you need help or have general support questions, than I hope this page helps you resolve those.   Do you need help or have general support questions, than I hope this page helps you resolve those.  
Line 17: Line 20:
     * The first thing to try in this case, is to [[resources:eval:user-guides:ev-cog-ad4050lz:tools:hardware_usb|drag and drop]] a known good .HEX or .BIN program into flash.(something with quick visible indicators works best)     * The first thing to try in this case, is to [[resources:eval:user-guides:ev-cog-ad4050lz:tools:hardware_usb|drag and drop]] a known good .HEX or .BIN program into flash.(something with quick visible indicators works best)
     * If drag and drop is not working, it may be necessary to erase the flash. To do so:       * If drag and drop is not working, it may be necessary to erase the flash. To do so:  
-      - Download and install the CrossCore Serial Flash Programmer from here: [[http://www.analog.com/en/design-center/processors-and-dsp/evaluation-and-development-software/crosscore-serial-flash-programmer.html#dsp-overview]].  +      - Download and install the CrossCore Serial Flash Programmer from here: [[adi>en/design-center/processors-and-dsp/evaluation-and-development-software/crosscore-serial-flash-programmer.html#dsp-overview]].  
       - Make sure that the USB is connected and on UART header (P8) 1 & 2 and 7 & 8 are shorted.        - Make sure that the USB is connected and on UART header (P8) 1 & 2 and 7 & 8 are shorted. 
       - Power cycle the EV-COG-AD4050LZ board while holding down the boot switch.        - Power cycle the EV-COG-AD4050LZ board while holding down the boot switch. 
Line 31: Line 34:
  
  
-\\ End Document \\ 
  
-**[[resources:eval:user-guides:ev-cog-ad4050lz|Back]]** 
 ===== Hardware, Software, and Documentation Questions ===== ===== Hardware, Software, and Documentation Questions =====
  
resources/eval/user-guides/ev-cog-ad4050lz/help_support.txt · Last modified: 03 Jan 2021 22:04 by Robin Getz

Page Tools