The most recent version of this page is a draft.
This version is outdated by a newer approved version.This version (26 Sep 2017 08:04) is a draft.
Approvals: 0/1
This version is outdated by a newer approved version.This version (26 Sep 2017 08:04) is a draft.Approvals: 0/1
This is an old revision of the document!
Table of Contents
CN0254 Evaluation Board Guide
Overview
CN0254 is a cost effective, highly integrated 16-bit, 250 kSPS, 8-channel data acquisition system that can digitize ±10 V industrial level signals. The circuit also provides 2500 V rms isolation between the measurement circuit and the host controller, and the entire circuit is powered from a single isolated PWM controlled 5 V supply.
The AD7689 16-bit, 8-channel, 250 kSPS PulSAR ADC contains all the necessary components for the multichannel low power data acquisition system. It includes a 16-bit SAR ADC, an 8-channel low crosstalk multiplexer, a low drift reference and buffer, a temperature sensor, a selectable one-pole filter, and a channel sequencer. The sequencer is useful for continuously scanning channels, and a microcontroller or FPGA is not required to control channel switching.
The AD8605 and AD8608 are low cost single and quad rail-to-rail input and output CMOS amplifiers. The AD8608 inverts, level shifts, and attenuates the ±10 V input signal so that it matches the input range of the ADC, which is 0 V to +4.096 V when using a +4.096 V reference and a +5 V single supply. The AD8605 acts as an external reference buffer to provide sufficient driving ability for level shifting. Both feature very low offset voltage, low input voltage and current noise, and wide signal bandwidth, therefore making them good choices for a wide variety of applications.
The ADuM3471 is a quad-channel digital isolator with an integrated PWM controller and transformer driver for an isolated dc-to-dc converter. It provides the isolated 5 V, 2 W power for the circuit as well as isolates the digital signals at the SPI interface.
The EVAL-CN0254-SDPZ board connects to ADI’s System Demonstration Platform (SDP) and is powered by a 6 V power supply.
Required Equipment
- EVAL-SDP-CB1Z Controller Board (SDP-B Board)
- DC Power Supply (6 V, 500 mA)
- PC with the following Minimum Requirements
- Windows® XP, Windows Vista (32-bit), or Windows 7 (32-bit)
- USB interface
General Setup
Block assignments
- The EVAL-CN0254-SDPZ (CN-0254 Board) connects to the EVAL-SDP-CB1Z (SDP-B Board) via the 120-Pin connector
- The EVAL-SDP-CB1Z (SDP-B Board) connects to the PC via the USB cable.
- Terminal block CN2 is the +6 V power supply input
Do not connect the USB cable to the Mini-USB connector on the SDP board before turning on the dc power supply for the EVAL-CN0254-SDPZ
resources/eval/user-guides/circuits-from-the-lab/cn0254.1506405883.txt.gz · Last modified: 26 Sep 2017 08:04 by Trisha Cabildo