Differences

This shows you the differences between two versions of the page.

--- university:tools:m2k:scopy:test-cases:digitalio [26 Jul 2017 13:14] – edit voltage values for logic levels Antoniu Miclaus
+++ university:tools:m2k:scopy:test-cases:digitalio [28 Aug 2017 14:56] – change voltmeter range Antoniu Miclaus
@@ Line 25: / Line 25: @@
 | ::: | 8. Monitor the voltage value via voltmeter. | {{:university:tools:m2k:scopy:test-cases:low-voltmeter.png?100|}} | On the voltmeter the voltage displayed is be between -0.050V and 0.4V. |
 | ::: | 9. Set channel 0 to logic state 1. | {{:university:tools:m2k:scopy:test-cases:high0.png?100|}} | The interface should look like in the "Step Resources" picture (left side).  |
-| ::: | 10. Monitor the voltage value via voltmeter. | {{:university:tools:m2k:scopy:test-cases:high-voltmeter.png?100|}} | On the voltmeter the voltage displayed should be between 2.9V and 3.3V. |
+| ::: | 10. Monitor the voltage value via voltmeter. | {{:university:tools:m2k:scopy:test-cases:high-voltmeter.png?100|}} | On the voltmeter the voltage displayed should be between 2.9V and 3.4V. |
 | ::: | 11. Set positive power supply to voltage level between 0V and 0.8V. | {{:university:tools:m2k:scopy:test-cases:ps-low.png?100|}} | The interface should look like in the "Step Resources" picture (left side). |
 | ::: | 12. Monitor the channel 7 logic state. | {{:university:tools:m2k:scopy:test-cases:7low.png?100|}} | Channel 7 indicates logic 0 level. |

Wiki