Differences

This shows you the differences between two versions of the page.

--- university:courses:eps:photovoltaic [19 Jul 2017 14:58] – [Directions:] Doug Mercer
+++ university:courses:eps:photovoltaic [24 Jul 2017 16:16] – change amplitude value to peak-peak Antoniu Miclaus
@@ Line 111: / Line 111: @@
 Set the frequency of waveform generator 1 to 20 Hz, and the horizontal time base so that at least one full 0 to V<sub>OC</sub> sweep is displayed.
-Set the amplitude of waveform generator 1 to slightly more than 2.5V ( >5V peak to peak ). Depending on the V<sub>GS</sub> of NMOS transistor M<sub>1</sub>, the offset of the generator will need to be set to -2.5 V + V<sub>GS</sub>. This may take a little experimentation to center the signal ramp applied to the solar panel.
+Set the amplitude of waveform generator 1 to slightly more than 5V. Depending on the V<sub>GS</sub> of NMOS transistor M<sub>1</sub>, the offset of the generator will need to be set to -2.5 V + V<sub>GS</sub>. This may take a little experimentation to center the signal ramp applied to the solar panel.
 ===== Procedure: =====

Wiki