Wiki

Analog Devices Wiki

English
English
简体中文
简体中文
日本語
日本語
Руccкий
Руccкий

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
university:courses:electronics:electronics-lab-lco [23 Mar 2017 16:35] – [Materials:] Doug Merceruniversity:courses:electronics:electronics-lab-lco [13 Jun 2022 20:07] (current) – [Background:] Doug Mercer
Line 25: Line 25:
 Below in figure 2 is the schematic and pinout for the CD4007: Below in figure 2 is the schematic and pinout for the CD4007:
  
-{{ :university:courses:electronics:cd4007.png?350 |}}+{{ :university:courses:alm1k:cd4007_pinout.png?400 |}}
  
 <WRAP centeralign> Figure 2 CD4007 CMOS transistor array pinout </WRAP> <WRAP centeralign> Figure 2 CD4007 CMOS transistor array pinout </WRAP>
Line 39: Line 39:
 ==== Directions: ==== ==== Directions: ====
  
-First build the simple example shown in figure 4 to test the input to output transfer function of the CMOS amplifier. The green boxes indicate connections to the connector on Analog Discovery. Connect V+ (+5V) power to V<sub>CC</sub> (pin 14) and ground to GND (pin 7). Connect the output of the waveform generator to one of the inverter inputs (pin 6) along with scope input 1+ and connect the inverter output (pin 8,13) to scope input 2+. +First build the simple example shown in figure 4 to test the input to output transfer function of the CMOS amplifier. The green boxes indicate connections to the connector on the ADALM2000. Connect V+ (+5V) power to V<sub>CC</sub> (pin 14) and ground to GND (pin 7). Connect the output of the waveform generator to one of the inverter inputs (pin 6) along with scope input 1+ and connect the inverter output (pin 8,13) to scope input 2+. 
  
 {{ :university:courses:electronics:alco_f4.png?500 |}} {{ :university:courses:electronics:alco_f4.png?500 |}}
Line 47: Line 47:
 ==== Hardware Setup: ==== ==== Hardware Setup: ====
  
-Configure the waveform generator for a 1 KHz triangle wave with 2.5V amplitude and 2.5V offset. Both scope channels should be set to 1V/Div.+Configure the waveform generator for a 1 KHz triangle wave with 5V amplitude peak-to-peak and 2.5V offset. Both scope channels should be set to 1V/Div.
  
 ==== Procedure: ==== ==== Procedure: ====
Line 96: Line 96:
 ==== Additional Activity: ==== ==== Additional Activity: ====
  
-Could you modify this circuit to make the frequency of the oscillator temperature dependent by substituting the photo resistor with the thermistor from the Analog Parts Kit?+Could you modify this circuit to make the frequency of the oscillator temperature dependent by substituting the photo resistor with the thermistor from the ADALP2000 Analog Parts Kit?
  
 **Return to Lab Activity [[university:courses:electronics:labs|Table of Contents]]** **Return to Lab Activity [[university:courses:electronics:labs|Table of Contents]]**
university/courses/electronics/electronics-lab-lco.txt · Last modified: 13 Jun 2022 20:07 by Doug Mercer

Page Tools