Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
university:courses:electronics:electronics-lab-21 [23 Mar 2017 16:34] – [Materials:] Doug Merceruniversity:courses:electronics:electronics-lab-21 [24 Jul 2017 16:08] – change amplitude value to peak-peak Antoniu Miclaus
Line 26: Line 26:
 ===== Directions: ===== ===== Directions: =====
  
-First build the simple example shown figure 2 to test the input to output transfer function of the simple CMOS amplifier. The green boxes indicate connections to the connector on Analog Discovery. Connect Vp (+5V) power to V<sub>CC</sub> (pin 14) and ground to GND (pin 7). Connect the output of the waveform generator to one of the inverter inputs (pin 1) along with scope input 1+ and connect the inverter output (pin 2) to scope input 2+. +First build the simple example shown figure 2 to test the input to output transfer function of the simple CMOS amplifier. The green boxes indicate connections to the connector on The ADALM2000. Connect Vp (+5V) power to V<sub>CC</sub> (pin 14) and ground to GND (pin 7). Connect the output of the waveform generator to one of the inverter inputs (pin 1) along with scope input 1+ and connect the inverter output (pin 2) to scope input 2+. 
  
 {{ :university:courses:electronics:a20_f2.png?500 |}} {{ :university:courses:electronics:a20_f2.png?500 |}}
Line 40: Line 40:
 ===== Hardware Setup: ===== ===== Hardware Setup: =====
  
-Configure the waveform generator for a 1 KHz triangle wave with 2V amplitude and 2.5V offset. Both scope channels should be set to 1V/Div.+Configure the waveform generator for a 1 KHz triangle wave with 4V amplitude and 2.5V offset. Both scope channels should be set to 1V/Div.
  
 ===== Procedure: ===== ===== Procedure: =====
Line 56: Line 56:
 ===== Hardware Setup: ===== ===== Hardware Setup: =====
  
-Configure the Network (Bode) analyzer for 2 log decades, end frequency of 100 KHz, a max gain of 2X, run time of 10 sec, offset of 0 V and an amplitude of V. Run a single sweep and save the data to a file.+Configure the Network (Bode) analyzer for 2 log decades, end frequency of 100 KHz, a max gain of 2X, run time of 10 sec, offset of 0 V and an amplitude of V. Run a single sweep and save the data to a file.
  
 =====Question: ===== =====Question: =====
university/courses/electronics/electronics-lab-21.txt · Last modified: 13 Jun 2022 20:06 by Doug Mercer