Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
university:courses:electronics:electronics-lab-12a [12 Jul 2019 13:38]
andreeapop [Activity 12-A. The Transresistance Amplifier]
university:courses:electronics:electronics-lab-12a [23 Aug 2019 13:12] (current)
amiclaus
Line 38: Line 38:
 <WRAP centeralign>​Figure 2 Transresistance amplifier input stage with current drive - Breadboard Circuit</​WRAP>​ <WRAP centeralign>​Figure 2 Transresistance amplifier input stage with current drive - Breadboard Circuit</​WRAP>​
  
-The first waveform generator, W1, should be configured for a 1 KHz sine wave with 800 mV amplitude and 0 offset. Channel one of the scope should be connected to display the output of the first generator and channel 2 should be set to display the output signal at 500 mV per division.+The first waveform generator, W1, should be configured for a 1 KHz sine wave with 800 mV amplitude ​peak-to-peak ​and 0 offset. Channel one of the scope should be connected to display the output of the first generator and channel 2 should be set to display the output signal at 500 mV per division.
  
 ==== Procedure: ==== ==== Procedure: ====
university/courses/electronics/electronics-lab-12a.txt · Last modified: 23 Aug 2019 13:12 by amiclaus