Wiki

Analog Devices Wiki

English
English
简体中文
简体中文
日本語
日本語
Руccкий
Руccкий

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
university:courses:electronics:electronics-lab-11m [12 Jul 2019 13:36] – [Activity 11M. The Source follower (NMOS)] Pop Andreeauniversity:courses:electronics:electronics-lab-11m [23 Aug 2019 13:06] – Antoniu Miclaus
Line 26: Line 26:
 <WRAP centeralign> Figure 2 Source Follower Breadboard Circuit </WRAP> <WRAP centeralign> Figure 2 Source Follower Breadboard Circuit </WRAP>
  
-The waveform generator should be configured for a 1 KHz Sine wave with 4 volt amplitude and 0 offset. The Single ended input of scope channel 2 (2+) is used to measure the voltage at the source. The Scope configured with channel 1+ connected to display the AWG generator output. When measuring the input to output error, channel 2 of the scope should be connected to display 2+ and 2- differential.+The waveform generator should be configured for a 1 KHz Sine wave with 4 volt amplitude peak-to-peak and 0 offset. The Single ended input of scope channel 2 (2+) is used to measure the voltage at the source. The Scope configured with channel 1+ connected to display the AWG generator output. When measuring the input to output error, channel 2 of the scope should be connected to display 2+ and 2- differential.
  
 ===== Procedure: ===== ===== Procedure: =====
Line 94: Line 94:
 <WRAP centeralign> Figure 8 Output Impedance Test Breadboard Circuit </WRAP> <WRAP centeralign> Figure 8 Output Impedance Test Breadboard Circuit </WRAP>
  
-The waveform generator should be configured for a 1 KHz Sine wave with 2 volt amplitude with the offset set equal to minus the V<sub>GS</sub> of M<sub>1</sub> ( approximately -V ). This injects a +/- 0.1mA (1V/10KΩ) current into M<sub>1</sub>'s source. Scope input 2+ measures the change in voltage seen at the source.+The waveform generator should be configured for a 1 KHz Sine wave with 2 volt amplitude peak-to-peak with the offset set equal to minus the V<sub>GS</sub> of M<sub>1</sub> ( approximately -V ). This injects a +/- 0.1mA (1V/10KΩ) current into M<sub>1</sub>'s source. Scope input 2+ measures the change in voltage seen at the source.
  
 ===== Procedure: ===== ===== Procedure: =====
university/courses/electronics/electronics-lab-11m.txt · Last modified: 07 Feb 2022 15:44 by Doug Mercer

Page Tools