Differences

This shows you the differences between two versions of the page.

--- university:courses:electronics:electronics-lab-10 [24 Jul 2017 15:25] – change amplitude value to peak-peak Antoniu Miclaus
+++ university:courses:electronics:electronics-lab-10 [18 Aug 2017 15:54] – add breadboard circuits + xy plots Antoniu Miclaus
@@ Line 24: / Line 24: @@
 ===== Hardware Setup: =====
+{{:university:courses:electronics:bandgap_sh_reg-bb.png|}}
+<WRAP centeralign> Figure 2 Band-gap shunt regulator Breadboard Circuit </WRAP>
 Waveform generator W1 should be configured for a 1 KHz triangle wave with 4 volt amplitude and 2V offset. The Single ended input of scope channel 2 (2+) is used to measure the regulated output voltage at the collector of Q<sub>3</sub>.
@@ Line 30: / Line 34: @@
 The regulated output voltage should be observed as the variable resistor R<sub>3</sub> is adjusted.
+<WRAP centeralign>{{:university:courses:electronics:bandgap_sh_reg-wav.png?500|}}</WRAP>
+<WRAP centeralign> Figure 3 output voltage vs. input voltage  </WRAP>
 {{ :university:courses:electronics:a10_f2.png?500 |}}
-<WRAP centeralign> Figure 2 output voltage vs. input current </WRAP>
+<WRAP centeralign> Figure 4 output voltage vs. input current </WRAP>
 =====Questions: =====

Wiki