Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
university:courses:alm1k:m2k-convert-labs [03 Nov 2018 17:32]
Doug Mercer add link to input didver how-to page
university:courses:alm1k:m2k-convert-labs [29 Jul 2019 02:03]
Doug Mercer [Notes:]
Line 11: Line 11:
 For the ALM1000 module we use the following terminology when referring to the connections to the connector and configuring the hardware. The analog I/O channel pins are referred to as CA and CB. For the ALM1000 module we use the following terminology when referring to the connections to the connector and configuring the hardware. The analog I/O channel pins are referred to as CA and CB.
  
-{{ :​university:​courses:​alm1k:​m2k-convert-f1.png?​200 |}}+{{ :​university:​courses:​alm1k:​m2k-convert-f1.png?​400 |}}
  
-<WRAP centeralign>​ALM1000 analog input/​output connector</​WRAP>​+<WRAP centeralign>​ALM1000 analog input/​output connector ​(left Rev D, Right Rev F</​WRAP>​
  
 When configured to force voltage / measure current –V is added as in CA-V or when configured to force current / measure voltage –I is added as in CA-I. When a channel is configured in the high impedance mode to only measure voltage –H is added as CA-H. The fixed power and ground connections are referred as GND, +5 and +2.5. When configured to force voltage / measure current –V is added as in CA-V or when configured to force current / measure voltage –I is added as in CA-I. When a channel is configured in the high impedance mode to only measure voltage –H is added as CA-H. The fixed power and ground connections are referred as GND, +5 and +2.5.
university/courses/alm1k/m2k-convert-labs.txt · Last modified: 29 Jul 2019 02:03 by Doug Mercer