This version is outdated by a newer approved version.DiffThis version (23 Jul 2012 16:51) was approved by Dragos Bogdan.

This is an old revision of the document!

This section presents the steps for developing an Arduino application that will run on the Digilent Cerebot MX3cK development board for controlling and monitoring the operation of the ADI part.

  • Under your Sketchbook directory create a folder called “Libraries”; this folder may already exist.
  • Unzip the downloaded file in the libraries folder.
  • Run the MPIDE environment.
  • You should see the new library under Sketch→Import Library, under Contributed.

  • Also you should see under File→Examples the demo project for the ADI library.
  • Select the ADIDriver example.

  • Select the Cerebot MX3cK board from Tools→Board.
  • Select the corresponding Serial Communication Port from Tools→Serial Port
  • The project is ready to be uploaded on the development board.

resources/tools-software/uc-drivers/microchip/arduino_software_design.1343055079.txt.gz · Last modified: 23 Jul 2012 16:51 by Dragos Bogdan