This version (18 May 2021 08:56) was approved by Nikhin Shetty.
Table of Contents
Click here to return to the Arithmetic and Logic page
One Shot Fall
Description
The One Shot Fall block outputs a trigger signal based upon the falling edge of the input signal. At the first falling edge of the input signal, the output signal will go high and remain high.In One Shot Fall Reset The output signal will remain high until a non-zero input signal is seen on the reset pin. The falling edge of the input signal is defined as any input signal level value changing to a lower signal level value.
Variants
- OneShotFall
- OneShotFallReset
Targets Supported
| Name | ADSP-214xx | ADSP-215xx/SC5xx | ADAU145x/146x |
|---|---|---|---|
| —————————— | ————————-- | ——————————-- | —————————- |
| OneShotFall | B/S | B/S | S |
| OneShotFallReset | B/S | B/S | S |
Pins
Input
| Name | Type | Description |
|---|---|---|
| ————————————— | —————————- | ————————————————- |
| Input | Audio | Input signal that is monitored for the first falling edge |
| Reset | Control | Resets the output trigger signal back to zero(only for OneShotFallReset) |
Output
| Name | Type | Description |
|---|---|---|
| ————————————— | —————————- | ————————————————-- |
| Output | Control | Sets bit position of the output “1” flag |
Configurable Parameters
| GUI Parameter Name | Default Value | Range | Function Description |
|---|---|---|---|
| —————————————— | ——————————- | ———————-- | ——————————————————- |
| Selected Bit | Bit:0 | Bit:30 | Sets bit position of Output'1' Flag. |
DSP Parameters
| Parameter Name | Description | ADSP-214xx/215xx/SC5xx | ADAU145x/6x |
|---|---|---|---|
| ———————————— | ———————————————————- | ———————————————- | ————————————— |
| BitVal | Compute & set the bit position value | FixInt32 | FixInt32 |
resources/tools-software/sigmastudiov2/modules/arithmeticandlogic/oneshotfall.txt · Last modified: 07 May 2021 07:48 by Krithika Manchale