This is an old revision of the document!
The Sawtooth Wave block generates a sawtooth wave (or saw wave) at a constant level and frequency. The output frequency is adjustable. Use the edit control or arrows to set the desired frequency; the checkbox control turns the signal on and off.. The gain and the initial phase of the algorithm can be configured.
To change the source's Sampling Rate, Right-click in the block and select Set Sampling Rate, which will open the Sampling Rate window (default is 44.1 kHz).
|GUI Control Name
|Turns the output of the cell on or off. When the output is off, the output pin will output a constant value of 0.
|0.01 to 0.5*Sample Rate
|The sets the frequency of the sawtooth that is output from the cell.
|0 to 360
|Initial Phase of the sawtooth signal.
|-144 to 42 dB / -134 to 24 db
|The gain to be multiplied on the sawtooth wave
This module can be grown to support multiple phase/gain values for a single sawtooth wave.