Differences

This shows you the differences between two versions of the page.

--- resources:tools-software:sigmastudio:toolbox:multirateprocessing:upsampling [21 Dec 2016 11:23] – Venkatesan Krishnamoorthy
+++ resources:tools-software:sigmastudio:toolbox:multirateprocessing:upsampling [12 May 2017 14:23] – Suhasini Raghuram
@@ Line 6: / Line 6: @@
 \\
 \\
-{{ :resources:tools-software:sigmastudio:toolbox:multirateprocessing:upsampler.jpg?nolink |}}
+{{ :resources:tools-software:sigmastudio:toolbox:multirateprocessing:upsampling.png?nolink |
 \\
-**Note:** Module does not do the low pass filtering after increasing the samples. It is the users responsibility to add a low pass filter after the up-sampling.
 ===== Input Pins =====
@@ Line 27: / Line 27: @@
 ^GUI Control Name^Default Value^Range^Function Description^
 |Upsample Factor|2| 2,3,4,6,8,16 |The factor at with the input sample rate will be multipiled|
+|LPF|Checked|Checked/Unchecked|If checked, a low pass filter will be applied after upsampling the signal|
 The upsampler can either insert zeros or repeat the previous sample(Zero Order Hold) during upsampling. This can be configured in the contex menu.
 {{ :resources:tools-software:sigmastudio:toolbox:multirateprocessing:upsample.png?nolink |}}
-Change in the 'Insertion Type' or 'Upsample Factor' needs a recompilation of the schematic.
+Change in the 'Insertion Type' , 'Upsample Factor' or 'LPF' needs a recompilation of the schematic.
 \\
 =====DSP Parameter Information=====

Wiki