Differences

This shows you the differences between two versions of the page.

--- resources:tools-software:linux-drivers:iio-transceiver:adrv9009 [11 Jan 2021 20:05] – remove wiki syntax in code block Robin Getz
+++ resources:tools-software:linux-drivers:iio-transceiver:adrv9009 [12 Jul 2021 15:56] – [Channel Enable/Powerdown Controls] Michael Hennerich
@@ Line 377: / Line 377: @@
 For use cases where pin control mode is not used or required, these attributes can be used to
 enable/disable the Rx/ORx/Tx signal paths while in the ENSM radio_on state.
-Rx and ORx channels **can not** be enabled at the same time, since they share the same converter.
+<note important>Rx and ORx channels **can not** be enabled at the same time, since they share the same converter. So when stitching from RX to ORx, first powerdown RX, then clear the powerdown controls on ORx </note>
 Writing 0, N or 1, Y to the below attributes either disables or enables the corresponding channel powerdown option.

Wiki