Differences

This shows you the differences between two versions of the page.

--- resources:fpga:xilinx:interposer:terminal_common [02 Jul 2013 09:22] – [Hardware Setup] Istvan Csomortani
+++ resources:fpga:xilinx:interposer:terminal_common [02 Jul 2013 12:02] – Correct typeos Istvan Csomortani
@@ Line 10: / Line 10: @@
   * Power the ADI evaluation board.
-At this point everything is set up and it is possible to start the evaluation of the ADI hardware through an UART terminal.
 ===== Configure Tera Term =====
@@ Line 23: / Line 22: @@
 {{ :resources:fpga:xilinx:interposer:teraterm_setup.png?400 }}
+After the configuration of the terminal was finished, the software application has to be uploaded and started on the configured system. This can be done by running the //Loadapp.bat// batch script, which can be found in the **LoadApp** directory.
+<WRAP tip>If the script threw an error, verify if the Xilinx EDK path specified in the **Loadapp.bat** script is corresponding with the current install path. If not change it to the correct one.</WRAP>

Wiki