Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
| resources:eval:user-guides:stingray:userguide [20 Jul 2022 13:29] – [Software/Digital Control] Sam Ringwood | resources:eval:user-guides:stingray:userguide [08 Nov 2022 18:14] – updated broken link in Evaluation Section Sam Ringwood |
|---|
| GPIO PINS ARE HI-Z! SEE [[#configuring_the_ltc2992|CONFIGURING THE LTC2992]]** | GPIO PINS ARE HI-Z! SEE [[#configuring_the_ltc2992|CONFIGURING THE LTC2992]]** |
| </note> | </note> |
| **4.** Initialize the ADAR1000s to put the ADAR1000-EVAL1Z into a known safe state with the ADTR1107 PAs pinched off. See the [[#Recommended ADAR1000 Initialization Sequence]] section for a recommended set of SPI writes. | **4.** Initialize the ADAR1000s to put the ADAR1000-EVAL1Z into a known safe state with the ADTR1107 PAs pinched off. See the [[:resources:eval:user-guides:stingray:userguide#recommended_adar1000_initialization_sequences|Recommended ADAR1000 Initialization Sequences]] section for a recommended set of SPI writes. |
| |
| **5.** Now that the ADTR1107 PAs are pinched off, +5V can safely be applied. This is accomplished by pulsing the **+5V_CTRL** signal. Once the +5V rail is up, a green LED (D4) is lit showing that the board is fully powered up. | **5.** Now that the ADTR1107 PAs are pinched off, +5V can safely be applied. This is accomplished by pulsing the **+5V_CTRL** signal. Once the +5V rail is up, a green LED (D4) is lit showing that the board is fully powered up. |
| [[resources/eval/user-guides/stingray|ADAR1000EVAL1Z Homepage]] | [[resources/eval/user-guides/stingray|ADAR1000EVAL1Z Homepage]] |
| |
| [[resources/eval/developer-kits/x-band-dev-kit|X Band Development Platform]] | [[:resources:eval:user-guides:x-band-platform|X Band Development Platform]] |
