This version is outdated by a newer approved version.
This version (25 May 2016 10:04) is a draft.
Approvals: 0/1The Previously approved version (18 May 2016 22:57) is available.
This version (25 May 2016 10:04) is a draft.Approvals: 0/1The Previously approved version (18 May 2016 22:57) is available.
This is an old revision of the document!
Table of Contents
ADRV9371/PCBZ Quick Start Guides
The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the ADRV9371-N/PCBZ, ADRV9371-W/PCBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.
Supported Carriers
The ADRV9371/PCBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:
Supported Environments
Hardware Setup
In most carriers, the ADRV9371/PCBZ board connects to the HPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.
ZC706 + ADRV9371/PCBZ
resources/eval/user-guides/mykonos/quickstart.1464163443.txt.gz · Last modified: 25 May 2016 10:04 by Michael Hennerich