This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
resources:eval:user-guides:inertial-mems:imu:adis1646x [28 Mar 2015 01:25] – [PHYSICAL SETUP] Mark Looney | resources:eval:user-guides:inertial-mems:imu:adis1646x [01 Feb 2016 18:08] – [SETUP] Mark Looney | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ====== ADIS1646X EVALUATION |
===== OVERVIEW ===== | ===== OVERVIEW ===== | ||
+ | Evaluating the [[adi> | ||
+ | |||
+ | |||
+ | |||
- | Insert product picture, with key feature annotations | ||
- | ===== SUMMARY ===== | ||
- | Brief description of the parts required to evaluate product with a PC | ||
Line 15: | Line 17: | ||
+ | =====SETUP===== | ||
+ | The physical setup requires only three simple steps: | ||
+ | 1. Install the DUT (for example, an ADIS16460AMLZ) onto the ADIS16IMU4/ | ||
+ | 2. Connect the ADIS16IMU4/ | ||
- | ===== SETUP ===== | + | 3. Set JP1 Jumper on EVAL-ADISZ |
- | The physical setup requires only three simple steps | + | |
- | Insert link from ADIS16IMU4/PCB Wiki Guide that describes installation of DUT onto breakout board | + | ====ADIS1646x Installation on the ADIS16IMU4/PCBZ==== |
+ | {{page> resources/ | ||
- | Insert link from ADIS16IMU4/PCB Wiki Guide that describes installation onto EVAL-ADIS | + | ====Connect the ADIS16IMU4/PCBZ to the EVAL-ADIS==== |
+ | {{page> resources/ | ||
- | Insert link from EVAL-ADIS | + | ====Set JP1 on the EVAL-ADIS==== |
+ | {{page> resources/ | ||
====IMU EVALUATION SOFTWARE OVERVIEW==== | ====IMU EVALUATION SOFTWARE OVERVIEW==== | ||