Differences

This shows you the differences between two versions of the page.

--- resources:eval:user-guides:eval-ad5940:software_examples:ad5940_ramp [08 Jul 2019 17:28] – Micheál Lambe
+++ resources:eval:user-guides:eval-ad5940:software_examples:ad5940_ramp [22 Oct 2019 17:03] (current) – Micheál Lambe
@@ Line 29: / Line 29: @@
   - Set S5 to Wall/USB to power the board from the USB cable{{ :resources:eval:user-guides:eval-adicup3029:reference_designs:img_20170612_144023_hdr.jpg?800 |}}
   - Place the **EVAL-AD5940ELCZ** on top of the **EVAL-ADICUP3029**.
-  - Ensure jumper on JP10 and JP11 is on PIN2 and PIN4 (to use the USB connected probe with EVAL-AD5940ELCZ, JP9,JP10 and JP11 should be configured to position C - pins 5 and 6)
+  - Ensure jumper on JP10 and JP11 is on PIN2 and PIN4 to connect the dummy sensor to the AD5940 (to use the USB connected probe with EVAL-AD5940ELCZ, JP9,JP10 and JP11 should be configured to position C - pins 5 and 6)
-  - Place jumper in position B on JP6 to connect the 1kΩ||3kΩ RE0 and SE0
+  - Place jumper in position B on JP6 to connect the 10kΩ||10kΩ resistor divider between RE0 and SE0
   - Plug in the micro USB cable into the (P10) USB port on the EVAL-ADICUP3029, and the other end into the PC or laptop.

Wiki