Differences

This shows you the differences between two versions of the page.

--- resources:eval:user-guides:circuits-from-the-lab:cn0566:software [08 Apr 2022 01:32] – Update figures, more GUI details Mark Thoren
+++ resources:eval:user-guides:circuits-from-the-lab:cn0566:software [08 Apr 2022 01:34] (current) – [GUI operation] add calibration command Mark Thoren
@@ Line 22: / Line 22: @@
 python3 cn0566_gui.py
 </code>
-which will print debug information to the console as shown below. In this case, gain and phase calibration files were not present, but a frequency measurement file for an HB100 was found.
+which will print debug information to the console as shown below. In this case, gain and phase calibration files were not present, but a frequency measurement file for an HB100 was found.\\
+**Typical console output:**
 <code>
 analog@phaser:~/pyadi-iio/examples/cn0566 $ python3 cn0566_gui.py
@@ Line 46: / Line 47: @@
 <WRAP centeralign> Figure 2. Uncalibrated Beam Pattern </WRAP>
-Close the GUI, Run the calibration routine to generate calibration files, then re-start. The beam should be much closer to ideal, with first side lobes approximately 13dB below the main lobe.
+Close the GUI, Run the calibration routine to generate calibration files:
+<code>
+python3 cn0566_examples.py cal
+</code>
+Then re-start the GUI. The beam should be much closer to ideal, with first side lobes approximately 13dB below the main lobe.
 {{ :resources:eval:user-guides:circuits-from-the-lab:cn0566:software:phaser_gui_beam_pattern.png?direct&800 |}}

Wiki