This version (19 Jan 2024 13:50) was approved by George Mois.The Previously approved version (19 Jan 2024 10:08) is available.
Table of Contents
ADRV9026 Quick Start Guides
The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the EVAL-ADRV9026/ADRV9029 boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program, or boot a Linux distribution.
Supported Carriers
The EVAL-ADRV9026/ADRV9029 is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:
| Board | EVAL-ADRV9026/ADRV9029 |
|---|---|
| ZCU102 | √ |
| Arria 10 SoC | WIP |
Supported Environments
The supported OS are:
| Board | HDL | Linux Software | No-OS Software |
|---|---|---|---|
| ZCU102 | √ | √ | √ |
| Arria 10 SoC | WIP | WIP | WIP |
Hardware Setup
The EVAL-ADRV9026/ADRV9029 boards connects to the HPC1 connector (unless otherwise noted). The carrier setup requires power (12VDC 3A MAX), UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.
ZCU102 + EVAL
Unboxing guide
Detailed description of the setup procedure for ADRV9009 (similar procedure for ADRV9026/9029):
resources/eval/user-guides/adrv9026/quickstart.txt · Last modified: 19 Jan 2024 13:50 by George Mois