Differences

This shows you the differences between two versions of the page.

--- resources:eval:user-guides:ad-fmcmotcon1-ebz:quickstart:chipscope [26 Feb 2014 17:44] – [Chipscope Interface] Andrei Cozma
+++ resources:eval:user-guides:ad-fmcmotcon1-ebz:quickstart:chipscope [10 Feb 2021 04:40] (current) – add retired Robin Getz
@@ Line 1: / Line 1: @@
 ====== AD-FMCMOTCON1-EBZ ISE Project with Chipscope ======
+{{page>/wiki/common#retired&nofooter&noheader}}
 This guide provides some quick instructions on how to setup the AD-FMCMOTCON1-EBZ on either:
   * [[http://www.zedboard.org/|ZED Board]], Rev C or later
@@ Line 20: / Line 20: @@
 ===== System Setup =====
-To setup the hardware follow the steps described in the [[http://wiki.analog.com/resources/eval/user-guides/ad-fmcmotcon1-ebz/quickstart/lv_setup_guide|Hardware Setup Guide]] section.
+To setup the hardware follow the steps described in the [[/resources/eval/user-guides/ad-fmcmotcon1-ebz/quickstart/lv_setup_guide|Hardware Setup Guide]] section.
 The FPGA must be programmed with the **top.bit** bitstream that results after compiling the ISE project. This has already been done, the bitstream was generated and it can be found in the ISE project's folder. To program the FPGA use the //**iMPACT**// tool from Xilinx.

Wiki