This version is outdated by a newer approved version.
This version (25 Feb 2016 14:22) was approved by Mihai Ionut Suciu.The Previously approved version (28 Aug 2015 13:10) is available.
This version (25 Feb 2016 14:22) was approved by Mihai Ionut Suciu.The Previously approved version (28 Aug 2015 13:10) is available.This is an old revision of the document!
Table of Contents
AD-FMCADC4-EBZ Quick Start Guides
The Quick Start Guides provide a simple step by step instructions on how to do an initial system setup for the AD-FMCADC4-EBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.
Supported Carriers
The AD-FMCADC4-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:
| Board | AD-FMCADC4-EBZ |
|---|---|
| ZC706 | v |
The supported OS are:
| Board | HDL | Linux Software | No-OS Software |
|---|---|---|---|
| ZC706 | v | v | - |
Hardware Setup
In most carriers, the AD-FMCADC4-EBZ board connects to the HPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A typical setup is shown below.
resources/eval/user-guides/ad-fmcadc4-ebz/quickstart.1456406531.txt.gz · Last modified: 25 Feb 2016 14:22 by Mihai Ionut Suciu