Differences

This shows you the differences between two versions of the page.

--- resources:eval:sdp:sdp-s:hardware_description [03 Aug 2011 12:46] – Added content & graphics Jean McAdam
+++ resources:eval:sdp:sdp-s:hardware_description [06 Oct 2011 16:35] (current) – Approved Jean McAdam
@@ Line 1: / Line 1: @@
-~~UNDERCONSTRUCTION~~under construction
-====== HARDWARE DESCRIPTION ======
+====== SDP-S Hardware Description ======
 This describes the hardware design of the EVAL-SDP-CS1Z board.
@@ Line 201: / Line 200: @@
 TThe mechanical specifications of the SDP-S board are 2.36 inch × 0.87 inch (60 mm × 22 mm). The tallest component on the top is approximately 0.17 inch (4.3 mm), and the tallest compo¬nents on the bottoms are the 120-pin connectors at approximately 0.152 inch (3.86 mm). Refer to Figure HWD5.
-{{:resources:eval:sdp:sdp-s:connector_mechspec.jpg|}}
+{{:resources:eval:sdp:sdp-s:connector_mechspec2.jpg|}}
 Figure HWD5: SDP-S Board Mechanical Specification

Wiki