Wiki

Analog Devices Wiki

English
English
简体中文
简体中文
日本語
日本語
Руccкий
Руccкий
This version (03 Jan 2021 22:10) was approved by Robin Getz.The Previously approved version (28 May 2012 13:54) is available.Diff

Table of Contents


ezLINX™ iCoupler® Isolated Interface Development Environment Homepage

ezLINX™ Power Supply Implementation

Power Input

An AC/DC desktop power supply is used to supply 7.5V input to the barrel connector J1 on the ezLINX hardware. This supply connects through a protection circuit as shown in Figure 1 below to the UNREG_IN node of the circuit.

Figure 1.

3.3V Power Supply

The ADP1864 Constant Frequency Current-Mode Step-Down DC-to-DC Controller is used with an external P-Channel Mosfet to generate the regulated 3.3V Power Supply for the ezLINX hardware. The circuit implementation of the 3.3V power supply is shown in below in Figure 2.

Figure 2.

1.2V, 2.5V and 5V Power Supplies

A P-Channel mosfet is used to regulate the 3.3V input to 1.2V, See Figure 3 below.

Figure 3.

The ADP1706 Linear regulator is used to regulate the 3.3V input to 2.5V, See Figure 4 below.

Figure 4.

The ADP3335 low dropout regulator is used to regulate the UNREG_IN input to 5V, See Figure 5 below.

Figure 5.

resources/eval/ezlinx/power.txt · Last modified: 03 Jan 2021 22:04 by Robin Getz

Page Tools