Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
university:tools:m2k:scopy:test-cases:network-analyzer [30 Apr 2021 10:03] Hannah Roseteuniversity:tools:m2k:scopy:test-cases:network-analyzer [30 Apr 2021 10:32] (current) Hannah Rosete
Line 19: Line 19:
 <hidden> <hidden>
 ^ Description ^ Test Steps ^ Steps Resources ^ Expected Results ^ ^ Description ^ Test Steps ^ Steps Resources ^ Expected Results ^
-| **Low Pass Filter: fc = 340 Hz** | 1.1 Create a first-order low pass RC filter with the following components: R = 470 Ohms, C = 1uF. This will have a cut-off frequency of approximately 340 Hz. | {{:university:tools:m2k:scopy:test-cases:NA-A1.01.png?100|}} | The set up must look like the image in the Steps Resources picture on the left. |+| **Low Pass Filter: fc = 340Hz** | 1.1 Create a first-order low pass RC filter with the following components: R = 470 Ohms, C = 1uF. This will have a cut-off frequency of approximately 340 Hz. | {{:university:tools:m2k:scopy:test-cases:NA-A1.01.png?100|}} | The set up must look like the image in the Steps Resources picture on the left. |
 | Reference: CH1 | 1.2 Set these configurations on the Network Analyzer: | {{:university:tools:m2k:scopy:test-cases:NA-A1.2.png?100|}} | Check the frequency response in the Bode plot. It must look like the image in the Steps Resources picture on the left. | | Reference: CH1 | 1.2 Set these configurations on the Network Analyzer: | {{:university:tools:m2k:scopy:test-cases:NA-A1.2.png?100|}} | Check the frequency response in the Bode plot. It must look like the image in the Steps Resources picture on the left. |
 |  | a. Reference: Channel 1, 1V Amplitude, 0V Offset |  |  | |  | a. Reference: Channel 1, 1V Amplitude, 0V Offset |  |  |
university/tools/m2k/scopy/test-cases/network-analyzer.txt · Last modified: 30 Apr 2021 10:32 by Hannah Rosete