This version (10 Nov 2020 06:54) was approved by Pop Andreea.The Previously approved version (13 Feb 2020 09:46) is available.
Table of Contents
Introduction to the ADALM2000
Basic Description
To use the ADALM2000 Active Learning Module, you have:
- Two-channel oscilloscope with differential inputs
- Two-channel arbitrary function generator
- 16-channel digital logic analyzer (3.3V CMOS and 1.8V or 5V tolerant, 100MS/s)
- 16-channel pattern generator (3.3V CMOS, 100MS/s)
- 16-channel virtual digital I/O
- Two input/output digital trigger signals for linking multiple instruments (3.3V CMOS)
- Two-channel voltmeter (AC, DC, ±25V)
- Network analyzer – Bode, Nyquist, Nichols transfer diagrams of a circuit. Range: 1Hz to 10MHz
- Spectrum Analyzer – power spectrum and spectral measurements (noise floor, SFDR, SNR, THD, etc.)
- Digital Bus Analyzers (SPI, I²C, UART, Parallel)
- Two programmable power supplies (0…+5V , 0…-5V)
- USB which for your host connectivity (used to stream data).
- USB 2 (480 Mbits/seconds)
- libiio USB device for communicating to the RF device
- Network device
- Remote Network Driver Interface Specification (RNDIS)
- This will enumerate with the
192.168.2.1IP address by default.
- USB serial device
- provides access to the Linux console on the M2K device via USB Communication Device Class Abstract Control Model (USB CDC ACM) specification
- Mass Storage Device : this will appear to the host as a disk, where you can find links for software uploads, and the serial number of the device.
- External Power.
- an external adapter (like this one from Adafruit).
Block Diagram
Pinout
university/tools/m2k/devs/intro.txt · Last modified: 10 Nov 2020 06:54 by Pop Andreea