This version is outdated by a newer approved version.
This version (26 Jul 2021 16:00) was approved by Robin Getz.The Previously approved version (15 Jun 2021 15:29) is available.
This version (26 Jul 2021 16:00) was approved by Robin Getz.The Previously approved version (15 Jun 2021 15:29) is available.This is an old revision of the document!
Table of Contents
ADALM2000 BNC Adapter Board
The AD-M2KBNC-EBZ is an ADALM2000 add-on board which allows the user to connect oscilloscope probes and other test leads to the analog inputs of M2K.
Figure 1. AD-M2KBNC-EBZ Top view
Features
- AC or DC coupling on all channels
- Possibility to reconfigure the analog inputs as differential input channels
- Access to all other ADALM2000 output pins
- Oscilloscope probes, BNC to grabber cables and mini grabber test clips are included in the package
Description
The AD-M2KBNC-EBZ has 2 single ended input channels and 2 single ended output channels. All these channels are terminated in a right-angle BNC connector which provides quick connection and a locking mechanism. The single ended input channels can be reconfigured as differential input channels by modifying a solder jumper on the bottom of the board. In this way, all 4 BNC connectors will be used for the analog input section and the output of the M2K is still available on the 30 pin header of the board.
Applications
- Electronic test and measurement equipment
- General-purpose signal processing applications
- Automated test equipment
- Educational applications
Package contents
- AD-M2KBNC-EBZ
- 2 x Oscilloscope Probes (PA360 60MHz x1 & x10 Passive Probe)
- 2 x BNC to grabber cables
- 10 x mini grabber test clips
Figure 2. AD-M2KBNC-EBZ Isometric view - Package contents
Getting started
The BNC adapter board is simply plugged into the ADALM2000 and can be used straight away. It does not need any supply or additional circuitry.
Figure 3. AD-M2KBNC-EBZ connected to ADALM2000
AC/DC Coupling
The input and output channels of this board can be AC or DC coupled using the shunt jumpers. In the following table is presented the jumper configuration:
| Jumper | Missing | Jumper 1-2 shorted | Jumper 2-3 shorted |
|---|---|---|---|
| S1- Analog In channel 1 | inoperable/disconnected | DC coupled | AC Coupled |
| S2- Analog In channel 2 | inoperable/disconnected | DC coupled | AC Coupled |
| P4- Analog Out channel 1 | inoperable/disconnected | DC coupled | AC Coupled |
| P5- Analog Out channel 2 | inoperable/disconnected | DC coupled | AC Coupled |
Schematics and CAD Files
university/tools/m2k/accessories/bnc.1627047281.txt.gz · Last modified: 23 Jul 2021 15:34 by Pop Andreea