Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
university:courses:electronics:electronics-lab-adc [24 Sep 2019 13:18]
andreeapop [Hardware Setup]
university:courses:electronics:electronics-lab-adc [24 Sep 2019 13:19] (current)
andreeapop [Procedure]
Line 88: Line 88:
 ==== Procedure ==== ==== Procedure ====
  
-Supply the circuit to +/-5V from the power supply. Configure AWG1 of the Signal Generator to Rising Ramp Sawtooth with 5V amplitude peak-to-peak,​ 2.5 offset and 100Hz frequency. Use AWG2 as 5V constant reference voltage for the ADC.+Supply the circuit to +/-5V from the power supply. Configure AWG1 of the Signal Generator to Rising Ramp Sawtooth with 5V amplitude peak-to-peak,​ 2.5 offset and 100Hz frequency. Use AWG2 as 5V constant reference voltage for the ADC.
  
 Configure the Logic Analyzer so that the digital channels DIO0, DIO1, DIO2 form a channel group decoded for Unary code and channels DIO6 and DIO7 form a channel group decoded for parralel output. Configure the Logic Analyzer so that the digital channels DIO0, DIO1, DIO2 form a channel group decoded for Unary code and channels DIO6 and DIO7 form a channel group decoded for parralel output.
university/courses/electronics/electronics-lab-adc.txt · Last modified: 24 Sep 2019 13:19 by andreeapop