Differences

This shows you the differences between two versions of the page.

--- university:courses:electronics:electronics-lab-adc [24 Sep 2019 13:18] – [Hardware Setup] Pop Andreea
+++ university:courses:electronics:electronics-lab-adc [24 Sep 2019 13:19] – [Procedure] Pop Andreea
@@ Line 88: / Line 88: @@
 ==== Procedure ====
-Supply the circuit to +/-5V from the power supply. Configure AWG1 of the Signal Generator to Rising Ramp Sawtooth with 5V amplitude peak-to-peak, 2.5 offset and 100Hz frequency. Use AWG2 as 5V constant reference voltage for the ADC.
+Supply the circuit to +/-5V from the power supply. Configure AWG1 of the Signal Generator to Rising Ramp Sawtooth with 5V amplitude peak-to-peak, 2.5 V offset and 100Hz frequency. Use AWG2 as 5V constant reference voltage for the ADC.
 Configure the Logic Analyzer so that the digital channels DIO0, DIO1, DIO2 form a channel group decoded for Unary code and channels DIO6 and DIO7 form a channel group decoded for parralel output.

Wiki