Differences

This shows you the differences between two versions of the page.

--- university:courses:electronics:electronics-lab-9 [12 Jul 2019 13:27] – Pop Andreea
+++ university:courses:electronics:electronics-lab-9 [23 Aug 2019 13:05] – Antoniu Miclaus
@@ Line 29: / Line 29: @@
 <WRAP centeralign> Figure 2 Regulator Version 1 Breadboard Circuit </WRAP>
-Waveform generator 1 should be configured for a 1 KHz triangle wave with 4 volt amplitude and 2V offset. The Single ended input of scope channel 2 (2+) is used to measure the stabilized output voltage at the collector of Q<sub>4</sub> ( negative inputs 1= and 2- should be connected to ground).
+Waveform generator 1 should be configured for a 1 KHz triangle wave with 4 volt amplitude peak-to-peak and 2V offset. The Single ended input of scope channel 2 (2+) is used to measure the stabilized output voltage at the collector of Q<sub>4</sub> ( negative inputs 1= and 2- should be connected to ground).
 ===== Procedure: =====
@@ Line 66: / Line 66: @@
 <WRAP centeralign> Figure 5 Regulator Version 2 Breadboard Circuit</WRAP>
-Waveform generator W1 should be configured for a 1 KHz triangle wave with 4 volt amplitude and 2V offset. Scope channel 2 (2+) is used to measure the stabilized output voltage at the emitter of Q<sub>4</sub>.
+Waveform generator W1 should be configured for a 1 KHz triangle wave with 4 volt amplitude peak-to-peak and 2V offset. Scope channel 2 (2+) is used to measure the stabilized output voltage at the emitter of Q<sub>4</sub>.
 ===== Procedure: =====

Wiki