Differences

This shows you the differences between two versions of the page.

--- university:courses:electronics:electronics-lab-6 [05 Mar 2019 12:29] – [Procedure] Antoniu Miclaus
+++ university:courses:electronics:electronics-lab-6 [12 Jul 2019 13:06] – Pop Andreea
@@ Line 1: / Line 1: @@
-====== Activity 6. BJT Current Mirror ======
+====== Activity: BJT Current Mirror ======
 ===== Objective: =====
@@ Line 30: / Line 30: @@
 ===== Hardware Setup: =====
-In the current mirror configuration, the op amp serves as a virtual ground at the mirror input (base) node to convert the voltage steps from AWG 2 ( W2 output ) into current steps through the 1KΩ resistor. The collector voltage is swept using a ramp from AWG 1(output W1) set to 3V peak to peak with the offset to 1.5V. V<sub>CE</sub> of output device Q<sub>2</sub> is measured differentially by scope inputs 1+, 1-. The mirror output current is measured by scope inputs 2+. 2- across 1KΩ resistor, R<sub>2</sub>.
+In the current mirror configuration, the op amp serves as a virtual ground at the mirror input (base) node to convert the voltage steps from AWG 2 ( W2 output ) into current steps through the 1KΩ resistor. The collector voltage is swept using a ramp from AWG 1(output W1). Load the stairstep.csv file, set amplitude to 1.5  (3V peak to peak) with the offset to 1.5V.
+V<sub>CE</sub> of output device Q<sub>2</sub> is measured differentially by scope inputs 1+, 1-. The mirror output current is measured by scope inputs 2+. 2- across 1KΩ resistor, R<sub>2</sub>.
 If you don't want to use the op-amp configuration the following simplified configuration can be used as well.

Wiki

Analog Devices Wiki

Differences

Analog Devices Wiki

Differences

Page Tools