Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
university:courses:electronics:electronics-lab-29 [05 Mar 2019 12:37]
amiclaus [Alternate component choices:]
university:courses:electronics:electronics-lab-29 [23 Aug 2019 14:04] (current)
amiclaus
Line 62: Line 62:
 <WRAP centeralign>​ Figure 5 Scopy screenshot </​WRAP>​ <WRAP centeralign>​ Figure 5 Scopy screenshot </​WRAP>​
  
-Now configure both AWG channels as square waves with 5 V amplitudes. Set AWG1 to a frequency of 1 KHz and AWG2 to a frequency of 2 KHz or twice AWG1. Set the phase of AWG2 to 0 degrees. Be sure to set the AWGs to run synchronously.+Now configure both AWG channels as square waves with 5 V amplitudes ​peak-to-peak. Set AWG1 to a frequency of 1 KHz and AWG2 to a frequency of 2 KHz or twice AWG1. Set the phase of AWG2 to 0 degrees. Be sure to set the AWGs to run synchronously.
  
 Observe the Q output on the scope screen with respect to the signals seen at the CLK and D inputs. Capture the various waveforms and save a screen shot for inclusion in your lab report. Observe the Q output on the scope screen with respect to the signals seen at the CLK and D inputs. Capture the various waveforms and save a screen shot for inclusion in your lab report.
university/courses/electronics/electronics-lab-29.txt · Last modified: 23 Aug 2019 14:04 by amiclaus