Differences

This shows you the differences between two versions of the page.

--- university:courses:electronics:electronics-lab-24 [12 Jul 2019 14:16] – Pop Andreea
+++ university:courses:electronics:electronics-lab-24 [23 Aug 2019 14:02] – Antoniu Miclaus
@@ Line 203: / Line 203: @@
 connected to the D input. The first scope channel 1 input should also be connected to Clock input. The
 second input scope channel 2 should be connected to the Q output of the flip-flop in figure 4. Both the
-AWG1 and AWG2 should be configured as a square wave with a 5 V amplitude and 2.5 V offset ( 0 - 5V
+AWG1 and AWG2 should be configured as a square wave with a 5 V amplitude peak-to-peak and 2.5 V offset ( 0 - 5V
 swing ). Set the frequency of AWG1 to 10 KHz and set the frequency of AWG2 to 5 KHz. Set the phase of
 AWG2 to 45 degrees. Be sure to configure the two AWG outputs to operate synchronously.
@@ Line 293: / Line 293: @@
 The AWG1 output and scope channel 1 input should both be connected to the input marked Clock in figure
 . The second input scope channel 2 should be connected to the Q output of the flip-flop in figure 5.
-The AWG1 should be configured as a square wave with a 5 V amplitude and 2.5 V offset ( 0 - 5V swing ).
+The AWG1 should be configured as a square wave with a 5 V amplitude peak-to-peak and 2.5 V offset ( 0 - 5V swing ).
 Set the frequency to 10 KHz.

Wiki