Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
university:courses:electronics:electronics-lab-13 [12 Jul 2019 13:40]
andreeapop
university:courses:electronics:electronics-lab-13 [23 Aug 2019 13:15] (current)
amiclaus
Line 43: Line 43:
 ===== Procedure: ===== ===== Procedure: =====
  
-Configure waveform generator for a 1 KHz sine wave with an amplitude of 400 mV and zero offset. Using scope channel 1 to observe the input at W1 and scope channel 2 to observe the output of the amplifier at R<​sub>​L</​sub>,​ record the input to output amplitude and phase relationship.+Configure waveform generator for a 1 KHz sine wave with an amplitude of 400 mV peak-to-peak ​and zero offset. Using scope channel 1 to observe the input at W1 and scope channel 2 to observe the output of the amplifier at R<​sub>​L</​sub>,​ record the input to output amplitude and phase relationship.
  
 {{ :​university:​courses:​electronics:​a13_wf_amp.png?​ |}} {{ :​university:​courses:​electronics:​a13_wf_amp.png?​ |}}
Line 98: Line 98:
 ===== Procedure: ===== ===== Procedure: =====
  
-Configure AWG1 for a 1 KHz sine wave with an amplitude of 2 V and zero offset. Using scope channel 1 to observe the input at W1 and scope channel 2 to observe the output of the amplifier, record the input to output amplitude and phase relationship.+Configure AWG1 for a 1 KHz sine wave with an amplitude of 2 V peak-to-peak ​and zero offset. Using scope channel 1 to observe the input at W1 and scope channel 2 to observe the output of the amplifier, record the input to output amplitude and phase relationship.
 {{ :​university:​courses:​electronics:​a13_wf_ug.png?​ |}} {{ :​university:​courses:​electronics:​a13_wf_ug.png?​ |}}
  
university/courses/electronics/electronics-lab-13.txt · Last modified: 23 Aug 2019 13:15 by amiclaus