Differences

This shows you the differences between two versions of the page.

--- university:courses:electronics:electronics-lab-10 [05 Mar 2019 12:26] – [Using an NPN transistor array:] Antoniu Miclaus
+++ university:courses:electronics:electronics-lab-10 [23 Aug 2019 13:05] – Antoniu Miclaus
@@ Line 1: / Line 1: @@
-====== Activity 10. Shunt regulator ======
+====== Activity: Shunt regulator ======
 ===== Objective: =====
@@ Line 29: / Line 29: @@
 <WRAP centeralign> Figure 2 Band-gap shunt regulator Breadboard Circuit </WRAP>
-Waveform generator W1 should be configured for a 1 KHz triangle wave with 4 volt amplitude and 2V offset. The Single ended input of scope channel 2 (2+) is used to measure the regulated output voltage at the collector of Q<sub>3</sub>.
+Waveform generator W1 should be configured for a 1 KHz triangle wave with 4 volt amplitude peak-to-peak and 2V offset. The Single ended input of scope channel 2 (2+) is used to measure the regulated output voltage at the collector of Q<sub>3</sub>.
 ===== Procedure: =====

Wiki