Wiki

Analog Devices Wiki

English
English
简体中文
简体中文
日本語
日本語
Руccкий
Руccкий

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
university:courses:electronics:comms-lab-polyphase-filter [27 Mar 2019 12:17] – [Procedure:] add ltspice files Antoniu Miclausuniversity:courses:electronics:comms-lab-polyphase-filter [23 Aug 2019 15:13] – Antoniu Miclaus
Line 94: Line 94:
 Turn on the power supplies. Connect scope input channel 2 through an AC coupling capacitor ( C<sub>4</sub> in figure 3 ) alternately to each of the four possible outputs at the ends of resistors R<sub>1</sub>, R<sub>2</sub>, R<sub>3</sub> and R<sub>4</sub>. Run a single frequency sweep and store each sweep in a waveform snapshot to compare each output's relative gain and phase response. Be sure to export all the frequency sweep data to a .csv file for further analysis in either Excel or Matlab. Turn on the power supplies. Connect scope input channel 2 through an AC coupling capacitor ( C<sub>4</sub> in figure 3 ) alternately to each of the four possible outputs at the ends of resistors R<sub>1</sub>, R<sub>2</sub>, R<sub>3</sub> and R<sub>4</sub>. Run a single frequency sweep and store each sweep in a waveform snapshot to compare each output's relative gain and phase response. Be sure to export all the frequency sweep data to a .csv file for further analysis in either Excel or Matlab.
  
-Using the scope and function generator software instruments ( in the time domain ) set the AWG frequency to the resonate frequency with the amplitude set to 1V. Trigger on scope channel 1. Observe the relative amplitudes and phases of the four outputs and store each waveform on channel 2 as a reference channel to compare the amplitude and phase of each output.+Using the scope and function generator software instruments ( in the time domain ) set the AWG frequency to the resonate frequency with the amplitude set to 1V peak-to-peak. Trigger on scope channel 1. Observe the relative amplitudes and phases of the four outputs and store each waveform on channel 2 as a reference channel to compare the amplitude and phase of each output.
 {{ :university:courses:electronics:appf_nf7.png?500 |}} {{ :university:courses:electronics:appf_nf7.png?500 |}}
  
university/courses/electronics/comms-lab-polyphase-filter.txt · Last modified: 25 Jun 2020 22:07 by 127.0.0.1

Page Tools