This version (11 May 2021 16:00) was approved by Prasad Kamath.The Previously approved version (19 Mar 2021 02:04) is available.
Table of Contents
Click here to return to the Master Control Port page
Master Control Port Status
Description
The master control port Status block sends out the Master control port status in the output pins. Master control errors can be cleared by setting input pin to non-zero value
Usage
Use the output pins to monitor master control port status and error. The error can be cleared by inputting a non-zero value at the input.
Targets Supported
| Name | ADSP-214xx | ADSP-215xx/ADSP-SC5xx | ADAU145x/1456x |
|---|---|---|---|
| —————————————- | —————————————— | ————————————————-- | ——————————————- |
| Master Control Port Status | Not Supported | Not Supported | Sample |
Pins
Input Pins
| Name | Type | Description |
|---|---|---|
| ————————— | ————————— | ———————————-- |
| ClearErrors | Control | Any non -zero value in the input clears the error. |
Output Pins
| Name | Type | Description |
|---|---|---|
| ————————— | ——————————- | ————————————-- |
| Status | Control | Outputs 1 while the Master control port is busy, otherwise outputs 0 |
| I2CErrorStatus | Control | It is a 2 bit value. Bit-0 is set if I2C error is encountered. Bit-1 is set when timeout error occurred. |
Configurable Parameters
Not applicable
DSP Parameters
Not applicable
DSP Parameter Computation
Not applicable
resources/tools-software/sigmastudiov2/modules/mastercontrolport/mastercontrolportstatus.txt · Last modified: 11 May 2021 16:00 by Prasad Kamath