This version (18 May 2021 09:01) was approved by John Joseph.The Previously approved version (05 May 2021 13:00) is available.
Table of Contents
Click here to return to the IO page
Input
Description
The Input block receives input from the hardware's input pins and makes it available in the schematic design.
Usage
Check the block for the input channel(s) you with to enable. Un-check the box disable an input channel. The pin will turn blue when an input is enabled and grey when disabled. The default block has two pins enabled, for stereo connection.
Every enabled input must be connected to an output, else there will be errors on compilation.
Only a single input block can be associated with a processor. You will receive an error if you attempt to add multiple inputs to a schematic.
To change the Input's Sampling Rate, Right-click the block name and select Set Sampling Rate, which will open the Sampling Rate window (default is 48 kHz):
Targets Supported
| Name | ADSP-214xx | ADSP-215xx/ADSP-SC5xx | ADAU145x/ADAU146x |
|---|---|---|---|
| ——————— | —————————- | ——————————————- | ——————————-- |
| Input | Block & Sample | Block & Sample | Sample |
Pins
Output
| Name | Type | Description |
|---|---|---|
| ——————————- | ————————————- | —————————-- |
| Output0 | Audio | Output channel 0 |
| Output1 | Audio | Output channel 1 |
Configurable Parameters
Not applicable
DSP Parameters
No DSP Parameters
resources/tools-software/sigmastudiov2/modules/inputoutput/input.txt · Last modified: 13 May 2021 09:34 by Prasad Kamath