This version (14 Sep 2022 13:54) was approved by Angu Sewa.The Previously approved version (10 May 2021 11:30) is available.
Table of Contents
Click here to return to the Basic page
Pulse Counter
Description
The Pulse Counter block, counts the number of inputs received. There is a start/stop pin to initiate and pause the count, and also a reset pin to set the count back to zero. Any non-zero input on the pulse input pin, is considered a pulse and will be counted when the count is enabled.
The pulse counter is to count the number of pulses in specified amount of time. The time is dictated by the signal on StartStop input pin. When the StartStop pin is high, counter starts counting pulses, otherwise the last count value is output. The Reset pin clears the count value and start from zero when StartStop pin is high.
Targets Supported
| Name | ADSP-214xx | ADSP-215xx/SC5xx | ADAU145x/146x |
|---|---|---|---|
| ———————————————————— | ——————-- | ——————————-- | —————————- |
| Pulse Counter | B/S | B/S | S |
Pins
Input
| Name | Type | Description |
|---|---|---|
| —————————— | ———————————————————— | —————————— |
| StartStop | Control | Starts/Pause the counter |
| Reset | Control | Resets the counter value |
| PulseIn | Control | Input to the counter |
Output
| Name | Type | Description |
|---|---|---|
| —————————— | ———————————————————— | —————————— |
| CountResult | Control | Outputs the count of non zero inputs to the counter |
resources/tools-software/sigmastudiov2/modules/basic/pulsecounter.txt · Last modified: 14 Sep 2022 13:54 by Angu Sewa