Wiki

The most recent version of this page is a draft.DiffThis version (10 Feb 2021 13:11) was approved by Sanjeeva Reddy.

This is an old revision of the document!


Click here to return to the Basic page

DSP Readback


Description

The DSP Readback block lets you read values back from the DSP at any point in your schematic design. The number displayed onscreen is the data value sent back from the DSP considering all the blocks to the left of the Readback block. Every time you click Read, this value will be updated with the latest from the DSP. By displaying the output value from any block, in any format desired, Readback is used chiefly for debugging, and probably will prove very handy.

Values can be read back in either hex or decimal. For the latter, you must specify what format you want the number to be displayed in. Any changes to this format will shift the decimal value of the number displayed.

Usage

The DSP Readback cell can be configured to read back from the target DSP repeatedly at regular intervals. To enable this mode, right-click the cell and select ReadValue.

Targets Supported

NameADSP-214xx(Sample)ADSP-214xx(Block)ADSP-215xx/ADSP-SC5xx(Sample)ADSP-215xx/ADSP-SC5xx(Block)
DSP Readback Yes YesYes Yes


Pins

Input

Input0AudioInput Channel 0

Output

Output0ControlOutput channel 0


Configurable Parameters

GUI Parameter NameDefault ValueRangeFunction Description


DSP Parameters

Parameter NameDescriptionADSP-214xx/SC5xx/215xx
ValueRead back value from the DSPFloat


/srv/wiki.analog.com/data/pages/resources/tools-software/sigmastudiov2/modules/basic/dspreadback.txt · Last modified: 12 May 2021 06:51 by Nikhin Shetty