This version is outdated by a newer approved version.
This version (18 May 2021 08:40) was approved by John Joseph.The Previously approved version (04 Feb 2020 06:00) is available.
This version (18 May 2021 08:40) was approved by John Joseph.The Previously approved version (04 Feb 2020 06:00) is available.This is an old revision of the document!
Table of Contents
Click here to return to the ADI Algorithms page
Dynamic Enhancement
Description
The Dynamic Enhancement block provides variable bass enhancement as a function of input-signal level. Lower levels require more bass than higher levels. The filter dynamically adjusts the amount of bass enhancement depending on the volume of the input signal, by using a variable-Q filter.
A fixed enhancement is applied to input levels below the threshold while a dynamic gain is applied to input levels above the threshold.
Variants
- Dynamic Enhancement (Mono)
- Dynamic Enhancement (Stereo)
Targets Supported
| Name | ADSP-214xx | ADSP-215xx/SC5xx | ADAU145x/146x |
|---|---|---|---|
| ———————————————— | ——————-- | ——————————-- | —————————- |
| Dynamic Enhancement (Mono) | B/S | B/S | NA |
| Dynamic Enhancement (Stereo) | B/S | B/S | NA |
Pins
Input
| Name | Type | Description |
|---|---|---|
| ———————- | ————-- | ———————- |
| Input0 | Audio | Input channel0 |
| Input1 | Audio | Input Channel1 (only for stereo) |
Output
| Name | Type | Description |
|---|---|---|
| ———————- | ————-- | ———————- |
| Output0 | Audio | Output channel0 |
| Output1 | Audio | Output channel1 (only for stereo) |
Configurable Parameters
| GUI Parameter Name | Default Value | Range | Function Description |
|---|---|---|---|
| —————————————- | ———————- | —————— | —————————————- |
| TimeConstant | 100 ms | 0 to 500ms | This controls the RMS time constant for the detector. Changing the attack and release rates |
| CompThreshold | -5 db | -24 to 20 dB | Threshold of the detector.Any signal coming into the detector below the threshold level will not influence the boost calculation. it receives a fixed enhancement. |
| CompressorRatio | 3 | 1 to 15 | It is dynamic boost ratio.Controls the rate at which the bass boost changes from the low to the high threshold. |
| BoostFrequency | 6 Hz | 0 to 16 Hz | Controls the maximum dynamic enhancement gain applied to the algorithm. |
| BassFrequency | 60 hz | 20 to 300 Hz | Cut off frequency for the boosting filter. |
DSP Parameters
| Parameter Name | Description | ADSP-214xx/SC5xx/215xx |
|---|---|---|
| —————————————- | —————————————————————————————— | —————————————- |
| CompThreshold | Threshold of the detector | Float |
| TimeConstant | Rms time constant for the detector for change in input signal level | Float |
| BoostFrequency | maximum dynamic enhancement gain applied to the algorithm | Float |
| BassFrequency | Cut off frequency for the boosting filter | Float |
resources/tools-software/sigmastudiov2/modules/adialgorithms/dynamicenhancement.1620711250.txt.gz · Last modified: 11 May 2021 07:34 by John Joseph