This shows you the differences between two versions of the page.

Previous revision
resources:tools-software:sigmastudio:toolbox:sources:vcowithquadratureoutputs [02 Aug 2012 21:04] (current) – Added toolbox hierarchy Brett Gildersleeve
Line 1: Line 1:
 +====== VCO with Quadrature Outputs ======
 +[[:resources:tools-software:sigmastudio:toolbox:sources|Click here to return to the Sources section.]]
 +|The voltage-controlled oscillator block, typically used for modulation applications, takes a control input signal (green pin) and outputs a sine tone at a particular frequency on the first blue pin, and a cosine signal (90 degree phase shifted copy of the signal) on the second blue pin.|{{ :resources:tools-software:sigmastudio:toolbox:sources:vco_q002.jpg}}|
 +\\ \\
 +The input value may be from zero to one (5.23 format), and the VCO linearly interpolates its derived value into an output frequency from 0 Hz (0.0 input) to fs/2 (1.0 input). Fs is the sampling frequency.
 +\\ \\
 +If the input applied is greater than 1, the derived output value will fold back to frequencies below fs/2.
 +\\ \\
 +To change the source's Sampling Rate, Right-click in the block and select Set Sampling Rate, which will open the Sampling Rate window (default is 44.1 kHz).
 +\\ \\
 +This cell can be found in the Voltage Controlled subfolder in the Sources section of the toolbox.
resources/tools-software/sigmastudio/toolbox/sources/vcowithquadratureoutputs.txt · Last modified: 02 Aug 2012 21:04 by Brett Gildersleeve