Wiki

Below is the source of this page. To edit this source as well as other pages on the wiki, you must login.

====== Voltage Controlled Oscillator Reset Phase ======

[[:resources:tools-software:sigmastudio:toolbox:sources|Click here to return to the Sources section.]]

|The voltage-controlled oscillator block (reset phase), typically used for modulation applications, takes a control input signal (second red pin) and outputs a sine tone at a particular frequency on the blue pin. It also has a control pin that resets the phase of the output signal.|{{ :resources:tools-software:sigmastudio:toolbox:sources:vco_004.jpg}}|
\\ \\
The input value may be from zero to one (5.23 format), and the VCO linearly interpolates its derived value into an output frequency from 0 Hz (0.0 input) to fs/2 (1.0 input). Fs is the sampling frequency.
\\ \\
If the input applied is greater than 1, the derived output value will fold back to frequencies below fs/2.
\\ \\
To change the source's Sampling Rate, Right-click in the block and select Set Sampling Rate, which will open the Sampling Rate window (default is 44.1 kHz).

Analog Devices Wiki

Page Tools