This version is outdated by a newer approved version.
This version (02 Aug 2012 16:30) was approved by Brett Gildersleeve.
This version (02 Aug 2012 16:30) was approved by Brett Gildersleeve.This is an old revision of the document!
Triangle Wave
| The Triangle Wave block generates a triangle wave at a constant level and frequency. The output frequency is adjustable. Use the edit control or arrows to set the desired frequency; the checkbox control turns the signal on and off. |  |
To change the source's Sampling Rate, Right-click in the block and select Set Sampling Rate, which will open the Sampling Rate window (default is 44.1 kHz).
Note: The triangle wave is digitally generated and is non-bandlimited. This waveform is suitable for use as an internal control signal, but will produce aliasing distortion if used directly for audio output. If this configuration is desired, it is recommended that you apply a low-pass filter to the block's output before routing the signal to hardware outputs.
resources/tools-software/sigmastudio/toolbox/sources/trianglewave.1343917853.txt.gz · Last modified: 02 Aug 2012 16:30 by Brett Gildersleeve